WCS - Two Rooms On List ?

[The Old Hobo]

I am up and hosting a test room using WCS.  I was wondering why I see two rooms in the channel listing with two different addys.  I can only get into one and when I type /channelname it give the channel name and Alternate channel name which is different.

[KM]

the second one only you will see (and then only if you are on primary), it is the loopback listing to join via loopback for those behind routers that wouldn't allow you to connect to yourself

[The Old Hobo]

For 3 days in a row when I start WCS It says it is Offline.  And it doesn't appear in the channel list.  Is the server down?  Should I redownload WCS.

I rebooted twice and it still says it is off line with no primary connections.

[Galactic Overlord]

Check your Config file and make certian the the Offline mode hasnt gotten turned on.....

Offline=0

Is what it should show.... if =1 change back to zero

[The Old Hobo]

The Offline mode is set to 0
22:37:07 Loading Config...
22:37:07 Offline Mode Disabled
22:37:07 Config Loaded
22:37:07 Attempting IP Detection...
22:37:07 Found IP: <EDIT>
22:37:07 Server Ready
 
Offline mode (for private rooms)
Offline=0

This is what I have in the config.  And it still says Offline

[edit]IP Removed by request of poster[/edit]

[KM]

what does it say at the top? it should say P=X/Y, i assume the X is 0, but what is the Y? or does it say offline mode even after saying offline mode disabled?

[The Old Hobo]

Reloaded WCS and reloaded the config file.  I have to configure the config, but thinks are working ok.  Thanks.  I figured out where the problems were in the config editing,